Products Guide

PEELSEAL – Use when it is necessary or desirable to remove the maskant, after processing, by peeling rather than solvent stripping.

PEELSEAL STRIPPER/REDUCER – To remove PEELSEAL after processing when solvent stripping is required or to reduce application viscosity.

SHARPSEAL -Use when a precise demarcation line is required.

SHARPSEAL, STRIPPER/REDUCER – To remove SHARPSEAL, after the plating job is completed. or to reduce application viscosity.

PROCOAT – A general purpose stop-off lacquer.

PROCOAT STRIPPER/REDUCER -To remove PROCOAT, after the plating job is completed, or to reduce application viscosity.

CHROMECOAT – Use when a stop-off lacquer is needed for hard chrome.

CHROMECOAT STRIPPER/REDUCER – To remove CHROMECOAT, after the plating job is completed, or to reduce the application viscosity.

ANOCOAT – Use when a stop-off lacquer is needed for anodizing.

ANOCOAT STRIPPER/REDUCER – To remove ANOCOAT, after the anodizing process, or to reduce the application viscosity.

MILLCOAT– Use when chemical milling aluminum.

MILLCOAT STRIPPER/REDUCER- Use when it is desirable to strip off MILLCOAT, after processing, rather than peeling or to reduce application viscosity.

E-COAT MASK-Use when a maskant is required for e-coating.

POWDERCOAT MASK-Use when a maskant is required for powder coating.

TEMPCOAT – Use when a temporary peelable coating is needed for mechanical protection only of surface finish for metals and glass.

PEELCOAT CLEAR-Use when a clear temporary peelable coating is needed for mechanical protection only of surface finish for metals and glass.

RACKCOAT– Use as a substitute for plastisol on part racks when an oven is not available or for short production runs. Spray or brush as required, use within hours.

BOOTHCOAT-Use as a peelable nonflammable water base paint booth coating to remove accumulated paint overspray.

MASKCOAT products are flammable liquids and are available in I gal., 5 gal., and 55 gal. containers. Also available in low VOC and VOC free formulations.