ANOCOAT
ANODIZING STOP-OFF LACQUER/MASKANT
Use as an anodizing stop off.
| ANOCOAT TECHNICAL DATA SHEET |
ANOCOAT is a fast dry solvent stop-off lacquer or liquid maskant that can be applied over a clean surface by brushing, dipping, or spray to the surface to be masked.
ANOCOAT can be used in most anodizing processes. For certain process requirements additional coats may be applied after solvent flash off. Under normal ambient conditions parts can enter the process within one to two hours after application.
ANOCOAT can be removed by stripping using ANOCOAT STRIPPER/REDUCER.
Use ANOCOAT STRIPPER/REDUCER to thin to spray viscosity if applying by spray.Cure may be accelerated by increasing ambient temperature.
ANOCOAT has an easy to detect green color to readily enable determination of application location, detection of inadvertent application and completeness of removal. The color intensity is intentionally light to enable a rough visual determination of application thickness.
ANOCOAT contains flammable solvents and is available in 1 gal., 5 gal., and 55 gal.
CHROMECOAT
STOP-OFF LACQUER FOR HARD CHROME PLATING
Use for stopping off hard chrome.
| CHROMECOAT TECHNICAL DATA SHEET |
CHROMECOAT is a fast dry solvent stop-off lacquer or liquid maskant that can be applied by brush, dip or spray to the surface to be masked. Under normal ambient conditions, parts may enter the plating cycle within one to two hours after application. This time can be reduced using elevated temperature and increased air flow. After minimal drying of the final process rinse.
CHROMECOAT is removed in minutes using CHROMECOAT STRIPPER/REDUCER.
CHROMECOAT is green in color to enable easy determination of application location, detection of inadvertent application, and completeness of removal. If more than one coat is required, additional coats may be applied after solvent flash off.
CHROMECOAT is a flammable liquid and is available in 1 gal., 5 gal.,and 55 gal. containers.
